# BU16 Paging Issue

**URL:** <https://forum.intech.studio/t/bu16-paging-issue/687>\
**Category:** The Lounge\
**Created:** [November 19, 2025, 11:19pm UTC](https://forum.intech.studio/t/bu16-paging-issue/687 "2025-11-19T23:19:30Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Maliska](https://forum.intech.studio/user_avatar/forum.intech.studio/maliska/32/322_2.png) [@Maliska](https://forum.intech.studio/u/Maliska)\
**Post date:** [November 19, 2025, 11:19pm UTC](https://forum.intech.studio/t/bu16-paging-issue/687/1 "2025-11-19T23:19:30Z")

</div>

Am I losing my mind? Most likely.  
I have a U16, which was working on my Dell Windows 10 PC for about a year, no issues.  
I moved to a new system (my old motherboard blew up), and now I am on a Dell with Windows 11.  
Now I know I am not doing anything fancy with my U16, as a matter of fact, I really use it as a glorified macro keyboard.

Anyway, I installed the new grid editor, and it had me update the firmware.  
So far, so good, but something I noticed after this any maybe it was always there and I just didn’t notice before.

The bottom right button (button 15) on each page is programmed to take you to the next page.  
Button 15 on page 0 takes me to page 1  
Button 15 on page 1 takes me to page 2  
Button 15 on page 2 takes me to page 3  
And lastly, Button 15 on page 3 takes me back to page 0

But what I have noticed is that going to each page is really fast, but going page to page 0 takes longer. Rather than right away it take 3+ second to load.  
Is this normal?  
Is this because I have more buttons active on page 0?

Kind Regards  
Mike

---

<div class="post-metadata">

**Author:** ![suku](https://forum.intech.studio/user_avatar/forum.intech.studio/suku/32/30_2.png) [@suku](https://forum.intech.studio/u/suku)\
**Post date:** [November 20, 2025, 9:13am UTC](https://forum.intech.studio/t/bu16-paging-issue/687/2 "2025-11-20T09:13:57Z")

</div>

Where there is more configuration on a page then it takes longer to load however this did not change in the last update as far as I know. Can you confirm that it was faster when you used the previous firmware? Can you double check by updating back to the older firmware?

---

<div class="post-metadata">

**Author:** ![Maliska](https://forum.intech.studio/user_avatar/forum.intech.studio/maliska/32/322_2.png) [@Maliska](https://forum.intech.studio/u/Maliska)\
**Post date:** [November 23, 2025, 3:40pm UTC](https://forum.intech.studio/t/bu16-paging-issue/687/3 "2025-11-23T15:40:39Z")

</div>

Thank you for the quick response.  
I will try to roll back an and check.  
I am sure it was j just didn’t notice and I was paying clothes for attention when I was updated to my new computer.

Thank you again.
